• Installed one or more NICs on the system.
• Installed protocol software if necessary.
• Installed all network drivers in the correct directories.
• Installed any network software required for the protocols. For more information, see the vendor's documentation.

After you run the setup program, you may need to complete one or more of these tasks to finish setting up Lotus Domino on the network:

• Change the default names assigned to Notes named networks to make them consistent with actual network topography.
• Fine-tune network port setup by adding, enabling, renaming, reordering, disabling, or deleting ports or by enabling network encryption or compression on a port.
• Complete tasks specific to the TCP/IP, or NetBIOS, protocol.

See also

Lotus Domino and networks

Glossary